Many customers think that the installation of fiberglass grilles in the car wash room requires a lot of technical expertise, but in fact, it is not. As long as sufficient preparation is done in advance, the installation of fiberglass grilles in the car wash room is very convenient. So what preparatory work needs to be done before installation?

1. Before installing the fiberglass grille in the car wash, it is necessary to make a special floor with a slope for easy drainage.

2. Special attention should be paid to the use of eight or five brick flat parking spaces (with beams made of single fiberglass grating).

3. Reserve a sedimentation tank next to the fiberglass grille in the car wash room for other purposes.

4. The size of the parking lot floor is 30cm from the middle to the middle of the bearing beam, about 10cm wide, with a self determined length and a height of about 7cm. A brick is removed from the beam every 1.2 meters, leaving a gap for water to flow.

5. When laying bricks, it is necessary to use cement with a higher grade, not afraid of spending money, and reserve a main drainage ditch around it to facilitate drainage and prevent water accumulation in the car wash room.

6. After the beam is fully cured, the car wash room fiberglass grating can be laid according to the cut size or as a whole board, and fixed with M fasteners and internal expansion screws. C-shaped fasteners can be used to fix each adjacent fiberglass grating plate. The fiberglass grating is divided into two sides, with the sliding surface facing upwards or the rough surface facing upwards.

7. The fiberglass grille in the car wash room can be polished into a slope or welded onto an iron plate to facilitate drainage and parking.

8. The raw materials for the fiberglass grille in the car wash room can be made of mustard resin and alkali free fiberglass. This type of fiberglass grille is sufficient to meet the requirements of the car wash room.

9. The car washing industry generally uses 38mm thick fiberglass grilles. The color of the fiberglass grilles in the car washing room is generally gray, and yellow, green, etc. can also be selected.

The technical personnel from the manufacturer of the fiberglass grille in the car wash room introduced that by doing these preparations well, the fiberglass grille can be installed correctly according to the installation requirements. After passing the inspection, it can be put into use.

After the preliminary preparation work is done, how should we install it in the later stage?

The installation of the fiberglass grille in the car wash room is very convenient. Just lay the board flat on the pre designed trench, leaving a 1-2cm gap for easy lifting and placing of the board.