The content of post processing for fiberglass round pipes: After demolding, the fiberglass steel pipes generally need to go through the following processing steps: cutting, turning, polishing, drying, sticking the pipe head, curing, testing, surface coating, packaging, and warehousing.

The working system of the post processing section for fiberglass round pipes: Depending on the working capacity of the processing equipment, this section can adopt a single shift working system.

Before cutting the machine, the capillary yard should be stacked with a rolled pipe by a machine shift, with a distance of generally 3-3.5 meters. The width is determined by the length of the pipe or the length of the equipment.

Drying: After cutting and polishing, before bonding the pipe joint, the pipe needs to be dried to remove moisture from the cutting surface, in order to facilitate bonding. Dry at 80 degrees for 25-30 minutes to achieve the intended drying effect. The cutting speed is about 1.2 minutes per piece.

The treatment of fiberglass round pipe joints: fiberglass round pipes are generally connected to fiberglass round pipes by sticking steel pipe heads at the pipe ends. Fiberglass round pipes need to be treated before they can be firmly bonded.