In general, the most commonly used specification for fiberglass grating is a hole spacing of 38 * 38, and the thickness of the grating with such hole spacing is 25mm, 30mm, and 38mm, respectively. Here, the editor will explain the usage instructions for fiberglass grating panels with a thickness of 38mm.
The single grid size of fiberglass grating with a thickness of 38mm is generally 38X38mm. The commonly used whole panel sizes are 1X4.04m, 1.22X3.66m, and 1.22X2.44m. Its upper auxiliary width is 6.5mm and lower auxiliary width is 5mm, with a weight of approximately 12kg/square meter. It is generally used in places where the load-bearing requirements are not high. Compared with other thicknesses of grating, its load-bearing capacity is relatively low, with a load-bearing range of about 3-4 tons.
We can see its presence in the following situations:
1. Municipal greening tree pool, tree pit cover plate
Tree pool cover plate is a fiberglass grating used to lay tree pits. The common names for tree pool cover plates are tree grates, tree fences, tree pool cover plates, etc., and their names vary due to local dialects. The specifications of the tree pond cover plate are generally 38 * 38 * 38 (unit: mm), and the overall size of the tree pond cover plate is mainly 1220 * 3660 and 1220 * 4000. Different sizes of tree pits require different sizes, and installation personnel can cut them according to their needs.
2. Cover plate for drainage ditch with only people
Due to the average load-bearing capacity of the 38mm thick fiberglass grating, it is necessary to pay attention to the width and inner diameter of the trench not exceeding 30cm when applying it to the trench cover, and it is only suitable for people to walk and cannot pass heavy objects such as vehicles.
3. Factory walkway board inspection channel floor cargo rack
Due to its good corrosion resistance, fiberglass grating with a thickness of 38mm can be used as pedestrian walkway boards, workshop inspection channels, and floor cargo racks in places with severe corrosion such as water treatment plants and electroplating plants.
4. Solar photovoltaic power generation pedal photovoltaic roof walkway board
Photovoltaic power generation pedals generally use 38mm thick fiberglass grilles with bright and long-lasting colors. A suitable amount of anti UV agent is added to the raw materials, which will not fade even under direct sunlight. It also has the characteristics of corrosion resistance, acid and alkali resistance, and is not afraid of wind and sun exposure. It is lightweight and flame-retardant.
The above is a summary of the load-bearing capacity and applicable scope of 38mm thick fiberglass grating by the editor. After reading this article, have you gained some understanding of fiberglass grating.
